How to install hardware of the autocom cdp pro for cars
#1
How to install hardware of the autocom cdp pro for cars
Recently, some customers asked us if we have 2014 release 2 CDP Delphi Software available and can be activated.We can't activate 2014.01 or 2014.02 autocom software yet, but we can update 2013.3 CDP Delphi Software to 2014.2 AUTOCOM CDP. Do you wanna know How to install hardware of the autocom cdp pro for cars.?
1.1 Insert the DVD in the computer's DVD reader. The installation starts automatically. (If the installation does not start, choose "Run" in the "Start"-menu and write D:\Start. Applies if the DVD reader is designated as unit D).
1.2 Enter your Product-ID, serial number, and hardware key. Then choose country and press "Next" to continue.
1.3 Check in the next window that correct product is chosen. From this window it is possible to show application tables, user manuals, release information, etc. This is done by choosing a document in the list and then pressing "View". Before continuing, it is important that you have read the system requirements. Press the button "View" under the heading "System requirements" to show the system requirements. Then confirm that you have read the system requirements and press "Next" to start the installation guide. Follow the guide to finish the installation.
2. Hardware
2.1 Introduction
The diagnostic unit has built-in interfaces for most communications available on the market that are used for OBD (On Board Diagnostic). For certain vehicle models, specific connectors are used for obd scanner . As accessories there are many unique cables enabling connection to the car's diagnostic connection autonumen.
Connection to PC takes place using any of the alternatives USB (Universal Serial Bus) or Bluetooth (wireless communication).
2.2 Connections
1. Bluetooth antenna
2. OBD 16-pin obd -II connector (SAE J1962)
3. Green/Yellow LED Yellow light Indicates communication using USB
Green/Yellow LED Green light Indicates communication using Bluetooth
4. Red LED Power
5. Green LED Test
6. USB-connection for PC
1.1 Insert the DVD in the computer's DVD reader. The installation starts automatically. (If the installation does not start, choose "Run" in the "Start"-menu and write D:\Start. Applies if the DVD reader is designated as unit D).
1.2 Enter your Product-ID, serial number, and hardware key. Then choose country and press "Next" to continue.
1.3 Check in the next window that correct product is chosen. From this window it is possible to show application tables, user manuals, release information, etc. This is done by choosing a document in the list and then pressing "View". Before continuing, it is important that you have read the system requirements. Press the button "View" under the heading "System requirements" to show the system requirements. Then confirm that you have read the system requirements and press "Next" to start the installation guide. Follow the guide to finish the installation.
2. Hardware
2.1 Introduction
The diagnostic unit has built-in interfaces for most communications available on the market that are used for OBD (On Board Diagnostic). For certain vehicle models, specific connectors are used for obd scanner . As accessories there are many unique cables enabling connection to the car's diagnostic connection autonumen.
Connection to PC takes place using any of the alternatives USB (Universal Serial Bus) or Bluetooth (wireless communication).
2.2 Connections
1. Bluetooth antenna
2. OBD 16-pin obd -II connector (SAE J1962)
3. Green/Yellow LED Yellow light Indicates communication using USB
Green/Yellow LED Green light Indicates communication using Bluetooth
4. Red LED Power
5. Green LED Test
6. USB-connection for PC
Thread
Thread Starter
Forum
Replies
Last Post
obdvip
Private For Sale/Trade Classifieds
0
11-25-2014 07:55 PM
vwporscheman
Private For Sale/Trade Classifieds
0
06-09-2005 07:03 PM